XTR-CAP-DRIVER

To remove the bolt cap on your Shimano-XTR-M9100 series crank arm using the Wheels Manufacturing XTR Cap Driver, follow these steps:

Removing the Bolt Cap

1. Place the XTR Cap Driver in the crank arm bolt cap, ensuring that it fits snugly.
2. Grab your 3/8" drive socket or torque wrench and insert it into the tool.
3. Turn the tool clockwise to remove the crank arm bolt cap. Apply steady, even pressure to avoid damaging the crank arm or bottom bracket.
4. Inspect the cap and the crank arm for any damage or wear, and replace any damaged components as needed.

To install the bolt cap, simply follow these steps:

1. Place the XTR Cap Driver in the crank arm bolt cap and make sure it's snug.
2. Use the tool with your 3/8" drive socket or torque wrench to turn the cap counterclockwise until it's snug.
3. For best results, use a torque wrench to ensure you're tightening the bolt to the manufacturer's recommended specifications.